Vol.11, No.4, November 2022.                                                                                                                                                                              ISSN: 2217-8309

                                                                                                                                                                                                                        eISSN: 2217-8333


TEM Journal



Association for Information Communication Technology Education and Science

Evaluation of Selected Parameters after Abrasive Water Jet Cutting of Wood Plastic Composite


Zuzana Mitaľová, František Botko, Juliána Litecká, Dušan Mitaľ


© 2022 Zuzana Mitaľová, published by UIKTEN. This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License. (CC BY-NC-ND 4.0)


Citation Information: TEM Journal. Volume 11, Issue 4, Pages 1547-1552, ISSN 2217-8309, DOI: 10.18421/TEM114-15, November 2022.


Received: 12 July 2022.

Revised:   19 September 2022.
Accepted:  23 September 2022.
Published: 25 November 2022.




Paper deals with cutting of composite material with natural reinforcement by AWJ (Abrasive Water Jet). The samples were cut with four different abrasive mass flow (from 150-300 g.min-1) and different traverse speeds (depending on the required cut quality Q according standard list). SN 214001 standard is used for evaluating of one selected parameter – edge radius (rk) by used a digital microscope. After the cutting, the weight loss/gain of the samples of the individual sets are also evaluated and conclusions formulated.


Keywords – – Composite Material, Abrasive Water Jet Edge Radius, Weight Loss.



Full text PDF >  



Copyright © 2022 UIKTEN
Copyright licence: All articles are licenced via Creative Commons CC BY-NC-ND 4.0 licence