Vol.8, No.3, August 2019.                                                                                                                                                                                ISSN: 2217-8309

                                                                                                                                                                                                                        eISSN: 2217-8333


TEM Journal



Association for Information Communication Technology Education and Science


Analysis regarding Dynamic Parameters of the Milling Head Bearings


Marek Kočiško, Anna Bašistová, Jozef Tkáč


© 2019 Anna Bašistová, published by UIKTEN. This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License. (CC BY-NC-ND 4.0)


Citation Information: TEM Journal. Volume 8, Issue 3, Pages 872-878, ISSN 2217-8309, DOI: 10.18421/TEM83-26, August 2019.


Received: 16 January 2019.

Revised:   26 July 2019.
Accepted: 31 July 2019.
Published:28 August 2019.




The quality of a lubricant used is a significant factor in the service life of bearings in operation. Nowadays, the development in the field of lubricants is advanced, and opens up additional possibilities for customers to extend the service life of the bearings. This paper deals with the parsing of the high-speed bearing of the milling head in the CNC milling cutter. The state of the bearings and contact surfaces was determined by the measurements and the analysis which was performed in order to assess the abrasion mode.


Keywords –Bearings, micro-geometry, vibration.



Full text PDF >  



Copyright © 2012-2019 UIKTEN, All Rights reserved
Copyright licence: All articles are licenced via Creative Commons CC BY-NC-ND 4.0 licence