Vol.9, No.3, August 2020.                                                                                                                                                                                ISSN: 2217-8309

                                                                                                                                                                                                                        eISSN: 2217-8333


TEM Journal



Association for Information Communication Technology Education and Science

Simulation and Optimization of the VTC200C Machining Center Production Plan


Marian Králik, Vladimír Jerz


© 2020 Marian Králik, published by UIKTEN. This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License. (CC BY-NC-ND 4.0)


Citation Information: TEM Journal. Volume 9, Issue 3, Pages 1295-1306, ISSN 2217-8309, DOI: 10.18421/TEM93-59, August 2020.


Received: 07 July 2020.

Revised:   15 August 2020.
Accepted: 20 August 2020.
Published: 28 August 2020.




The paper describes the use of the Plant Simulation software to create a simulation model of the manufacturing process in the VTC200C machining centre. A genetic algorithm was used to optimize the production process. It is an algorithm that learns itself and looks for the best solution based on input data. The optimization is done based on the assessment of the output data from the simulation model. Based on the results of the optimization, a more efficient production plan was designed in the selected company.


Keywords –simulation, optimization, machining centre, production plan, Plant Simulation.



Full text PDF >  



Copyright © 2012-2020 UIKTEN, All Rights reserved
Copyright licence: All articles are licenced via Creative Commons CC BY-NC-ND 4.0 licence