Vol.9, No.2, May 2020.                                                                                                                                                                                     ISSN: 2217-8309

                                                                                                                                                                                                                        eISSN: 2217-8333


TEM Journal



Association for Information Communication Technology Education and Science

Monitoring of the Impacts of Used Materials for Resulting Attributes of an Electric Motor

Created via Additive Technology


Jozef Török, Martin Pollák, Monika Töröková, Zuzana Murčinková, Marek Kočiško


© 2020 Jozef Török, published by UIKTEN. This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License. (CC BY-NC-ND 4.0)


Citation Information: TEM Journal. Volume 9, Issue 2, Pages 826-830, ISSN 2217-8309, DOI: 10.18421/TEM92-54, May 2020.


Received: 18 April 2020.

Revised:   15 May 2020.
Accepted: 22 May 2020.
Published: 27 May 2020.




The article discusses the possibilities of production of a brushless electric motor with usage of additive technologies and verification the functionality of the design. A few electromotor stators have been produced by 3D printing. They were made of PLA plastic with different admixtures to increase the intensity of the magnetic field. The contribution at the end offers a comparison comprising the individual measurements and the efficiency of the electric motor.


Keywords –additive technology, electromotor, AC electric motor, PLA plastic.



Full text PDF >  



Copyright © 2012-2020 UIKTEN, All Rights reserved
Copyright licence: All articles are licenced via Creative Commons CC BY-NC-ND 4.0 licence